Test 133E - Bus Short To Battery
Ensure all doors are closed and courtesy lights are off. Using scan tool in ohmmeter mode, measure resistance on anti-lock brake controller connector, terminals No. 11, 12 and 24 (Black wires). If resistance is 5 ohms or greater, repair applicable open Black wire. If resistance is less than 5 ohms, replace anti-lock brake controller.
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.