LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1995 >> LHS >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Test 9A >> Correcting Left Front Sensor Faults
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Correcting Left Front Sensor Faults

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAM.
  1. Inspect left front WSS for damage, contamination or looseness. If WSS is faulty, replace WSS. Perform TEST VER-1A. If WSS is okay, go to next step.
  2. Inspect left front tone wheel for damage or excessive runout. If tone wheel is faulty, replace tone wheel and outer CV joint as an assembly. Perform TEST VER-1A. If tone wheel is okay, go to next step.
    NOTE: Wheel Speed Sensor (WSS) air gap is not adjustable.
  3. Measure air gap between WSS and tone wheel. If gap is not .020-.060" (.52-1.64 mm), replace WSS. Perform TEST VER-1A. If gap is .020-.060" (.52-1.64 mm), go to next step.
  4. Inspect WSS wiring harness for damage. If wiring harness is faulty, repair as necessary. Perform TEST VER-1A. If wiring harness is okay, go to next step.
  5. Disconnect left front WSS connector. Inspect, clean or repair connector as necessary. Using an external ohmmeter, check resistance between WSS male connector terminals. If resistance is not 950-1250 ohms, replace WSS. Perform TEST VER-1A. If resistance is 950-1250 ohms, replace CAB. Perform TEST VER-1A.
scientia non olet · About LEMON Manuals