Test 74A - Gauges Do Not Go To Zero With Key Off
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see appropriate article in ENGINE PERFORMANCE:
- WIRING DIAGRAMS - 3.3L
- WIRING DIAGRAMS - 3.5L
- Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
Turn ignition off. Disconnect instrument cluster Black connector. Using scan tool in voltmeter mode, check voltage on instrument cluster Black connector terminal No. 8 (Pink/Red wire). If voltage is less than 10 volts, repair open Pink/Red wire. If voltage is more than 10 volts, replace instrument cluster.