Pump/Motor Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.

Using scan tool, stop pump/motor actuation. Ensure jumper wire is still connected. Turn ignition off. Remove pump/motor relay. Disconnect CAB 60-pin connector. Inspect, clean and repair connector as necessary. Using scan tool in ohmmeter mode, check resistance of CAB 60-pin connector terminal No. 16 (Gray wire). If resistance is more than 5 ohms, repair open in Gray wire. Perform TEST VER-1A. If resistance is less than 5 ohms, replace CAB. Perform TEST VER-1A.