Right Front Wheel Speed Sensor Continuity Fault

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.

Using an external ohmmeter, check resistance between CAB connector terminals No. 6 (White/Dark Blue wire) and No. 7 (White wire). If resistance is less than 5 ohms, repair White/Dark Blue and White wires for short to each other. Perform TEST VER-1A. If resistance is more than 5 ohms, go to next step.
Disconnect right front WSS. Connect a jumper wire between chassis ground and terminal No. 1 (White wire) of right front WSS. Using scan tool in ohmmeter mode, check resistance of CAB connector terminal No. 7 (White wire). If resistance is less than 5 ohms, repair open in White/Dark Blue wire. Perform TEST VER-1A. If resistance is more than 5 ohms, repair open in White wire. Perform TEST VER-1A.