LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1995 >> LeBaron >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Test 6A >> Left Rear Wheel Speed Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Left Rear Wheel Speed Sensor

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.
  1. Using scan tool, read trouble codes. If scan tool displays LR WSS CONTINUITY fault, go to TEST 8A. If scan tool does not display LR WSS CONTINUITY fault, go to next step.
  2. Raise vehicle on a hoist. Inspect left rear tire. If tire wear is excessive, replace tire. Perform TEST VER-1A. If tire wear is not excessive, go to next step.
  3. Rotate left rear tire by hand. If tire is difficult to rotate, repair dragging brakes. Perform TEST VER-1A. If tire rotates with minimal resistance, go to next step.
  4. Using scan tool, read LR WSS signal while rotating left rear tire. If scan tool shows greater than zero MPH, go to TEST 6B. If scan tool does not show greater than zero MPH, go to next step.
  5. Inspect left rear tone wheel for damage (chipping or cracking). If tone wheel is damaged, replace tone wheel. Perform TEST VER-1A. If tone wheel is okay, go to next step.
  6. Inspect left rear Wheel Speed Sensor (WSS) for damage and proper connection. If left rear WSS is damaged or loose, replace or repair left rear WSS as necessary. Perform TEST VER-1A. If left rear WSS is not damaged or loose, go to next step.
  7. Disconnect left rear WSS connector. Turn ignition on. Using an external voltmeter, check voltage across sensor terminals. If voltage does not switch from zero to 2 or more volts, replace CAB. Perform TEST VER-1A. If voltage switches from zero to 2 or more volts, replace left rear WSS. Perform TEST VER-1A.
scientia non olet · About LEMON Manuals