LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1995 >> LeBaron >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Test 9D >> Modulator Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Modulator Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.
  1. Stop actuator test. Turn ignition off and close all doors. Disconnect CAB 60-pin connector. Inspect, clean and repair connector as necessary. Turn ignition on. Using scan tool in ohmmeter mode, check resistance of CAB connector terminal No. 46 (Brown/Light Blue wire). If resistance is less than 5 ohms, repair short to ground in Brown/Light Blue wire. Perform TEST VER-1A. If resistance is more than 5 ohms, go to next step.
  2. Reconnect modulator assembly 10-pin connector. Using scan tool in ohmmeter mode, check resistance of CAB connector terminal No. 46 (Brown/Light Blue wire). If resistance is more than 5 ohms, repair open in Brown/Light Blue wire. Perform TEST VER-1A. If resistance is less than 5 ohms, replace CAB. Perform TEST VER-1A.
scientia non olet · About LEMON Manuals