LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1995 >> LeBaron >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 17A - Courtesy Lamps Inoperative
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 17A - Courtesy Lamps Inoperative

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS - 3.0L article in ENGINE PERFORMANCE. Perform TEST VER-1 after each repair.
  1. Using scan tool, actuate courtesy lamps. If courtesy lamps cycle on and off, go to TEST 17C . If courtesy lamps do not cycle on and off, go to next step.
  2. Using scan tool, stop courtesy lamp actuation. Remove and inspect fuse No. 13 in fuse panel. See Figure. If fuse is open, go to TEST 17B. If fuse is okay, go to next step.
  3. Using scan tool in voltmeter mode, check voltage on fuse No. 13 (Pink wire). If voltage is less than 10 volts, repair Pink wire as necessary. If voltage is more than 10 volts, reinstall fuse and go to next step.
  4. Gain access to any inoperative courtesy lamps. If voltage is less than 10 volts, repair open in Pink wire to bulb. If voltage is more than 10 volts, go to next step.
  5. Access Body Control Module (BCM), located behind right kick panel. Disconnect BCM Black connector. Check voltage on BCM Black connector terminal No. 25 (Yellow wire). If voltage is less than 10 volts, repair open in Yellow wire. If voltage is more than 10 volts, replace BCM.
scientia non olet · About LEMON Manuals