LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1995 >> LeBaron >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 58A - Tail Lamp Out
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 58A - Tail Lamp Out

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS - 3.0L article in ENGINE PERFORMANCE. Perform TEST VER-1 after each repair.
  1. Turn ignition off. Disconnect lamp outage module 5-pin connector. Check, clean and repair connections as needed. Reconnect lamp outage module 5-pin connector. Turn ignition on. If EVIC panel does not display TAIL LAMP OUT, replace lamp outage module. If EVIC panel displays TAIL LAMP OUT, go to next step.
  2. Turn ignition off. Disconnect Body Control Module (BCM) Natural connector. Check, clean and repair connections as needed. Turn ignition off. Using scan tool in ohmmeter mode, check resistance of BCM Natural connector terminal No. 3 (Brown/Yellow wire). If resistance is less than 5 ohms, repair Brown/Yellow wire between BCM Natural connector and lamp outage module connector for short to ground. If resistance is more than 5 ohms, replace BCM.
scientia non olet · About LEMON Manuals