Test 75A - Seat Belt Lamp Problem

CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS - 3.0L article in ENGINE PERFORMANCE. Perform TEST VER-1 after each repair.

Turn ignition on. If seat belt warning lamp does not illuminate, go to TEST 75B. If seat belt warning lamp illuminates, wait 10 seconds. If seat belt warning lamp is still on, go to TEST 75C . If seat belt warning lamp goes off, system is operating properly at this time.