Test VER-1 - Verification Procedure
- Reconnect all previously disconnected components and connectors. Ensure all repairs have been made. Using scan tool, erase Diagnostic Trouble Codes (DTCs). Turn ignition off. Wait 5 seconds. Turn ignition on. Go to next step.
- Fully operate system that was malfunctioning by turning switch on, opening door, etc. If system does not operate properly, go to TEST 1A. If system operates properly, go to next step.
- Using scan tool, read body control module DTCs. If any DTCs return, go to TEST 1B. If no DTCs return, repair is complete.