Test 7B - Bus Short To Battery
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAMS - 3.0L
article in ENGINE PERFORMANCE. After each repair, perform TEST VER-1.
CAUTION:
Always turn ignition switch to OFF position before disconnecting or connecting any module connector.
- Using an external ohmmeter, check resistance between Powertrain Control Module (PCM) connector terminals No. 7 (Orange wire) and No. 26 (Violet/Brown wire). If resistance is less than 5 ohms, repair short between Violet/Brown wire and Orange.
- If resistance is more than 5 ohms, check resistance between PCM connector terminals No. 7 (Orange wire) and No. 46 (White/Black wire). If resistance is less than 5 ohms, repair short between White/Black wire and Orange wire. If resistance is more than 5 ohms, replace PCM.