Test 11M - No Termination

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION in BODY CONTROL COMPUTER. For wiring diagrams, see article in ENGINE PERFORMANCE:

WIRING DIAGRAMS - 2.0L & 2.4L
WIRING DIAGRAMS - 2.5L V6
After each repair, perform TEST VER-1 .

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
1. This test applies to FJ22 and F24S bodies only. Turn ignition off, and disconnect Transmission Control Module (TCM). Using an external ohmmeter, check resistance between TCM terminals No. 5 and No. 44. If resistance is not 100-140 ohms, replace TCM.
2. If resistance is 100-140 ohms, check resistance of Black/Dark Blue wire between 12-pin Data Link Connector (DLC) terminal No. 7 and TCM connector terminal No. 43. If resistance is more than 5 ohms, repair open Black/Dark Blue wire.
3. If resistance is less than 5 ohms, check resistance of White/Dark Blue wire between 12-pin DLC terminal No. 8 and TCM terminal No. 4. If resistance is more than 5 ohms, repair open White/Dark Blue wire.
4. If resistance is less than 5 ohms, check resistance of Black/Dark Blue wire between TCM connector terminals No. 5 and No. 43. If resistance is more than 5 ohms, repair open Black/Dark Blue wire.
5. If resistance is less than 5 ohms, check resistance of White/Dark Blue wire between TCM connector terminals No. 4 and No. 44. If resistance is more than 5 ohms, repair open White/Dark Blue wire. If resistance is less than 5 ohms, replace scan tool cable or scan tool cartridge as necessary.