Test 104F - Wiper Switch Power Supply
NOTE:
For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER
section in this article. Perform TEST VER-1
VERIFICATION TEST after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Remove and inspect fuse No. 10 in the junction block. See Figure . Junction block is located behind end cover, on left side of instrument panel. If fuse is blown, go to TEST 104G. If fuse is not blown, go to next step.
- Using scan tool in voltmeter mode, check voltage on fuse No. 10 (Black/White wire). If voltage is more than 10 volts, repair open Dark Blue wire. If voltage is 10 volts or less, repair open Black/White wire.