Test 100A - All Doors (Except Left Front) Fail To Lock
NOTE:
For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER
section in this article. Perform TEST VER-1
VERIFICATION TEST after each repair.
- Remove key from ignition switch. Remove door lock relay from junction block. See Figure . Junction block is located behind end cover, on left side of instrument panel. Go to next step.
- Using scan tool in ohmmeter mode, check resistance of door lock relay connector terminal "E" (Black wire). If resistance is 5 ohms or greater, repair open Black wire. If resistance is less than 5 ohms, go to next step.
- Using scan tool in voltmeter mode, check voltage on door lock relay connector terminal "C" (Orange/White wire). Depress and hold door lock switch to LOCK position. If voltage is 10 volts or less, repair open Orange/White wire. If voltage is more than 10 volts, replace door lock relay.