Test 102B - Problem With Remote Keyless Entry
NOTE:
For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER
section in this article. Perform TEST VER-1
VERIFICATION TEST after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Gain access to the Remote Keyless Entry (RKE) module. See Figure . Disconnect RKE module Black connector. Go to next step.
- Using scan tool in ohmmeter mode, check resistance of RKE Black connector terminal "H" (Black wire). If resistance is less than 5 ohms, replace RKE module. If resistance is 5 ohms or greater, repair open Black wire.