Test 45A - Headlights Will Not Turn Off
NOTE:
For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER
section in this article. Perform TEST VER-1
VERIFICATION TEST after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Disconnect headlight switch 8-pin connector from behind switch. If headlights go off, replace headlight switch. If headlights do not go off, go to next step.
- Turn ignition off. Disconnect Body Control Module (BCM) connectors. BCM is located behind right kick panel. If headlights go off, replace BCM. If headlights do not go off, go to next step.
- Disconnect headlight time delay relay from junction block. See Fig 1 . Junction block is located behind end cover, on left side of instrument panel. If headlights do not go off, repair short to battery voltage in Light Green wire. If headlights go off, go to next step.
- Using scan tool in ohmmeter mode, check resistance of headlight delay relay connector terminal "E" (Red/Dark Blue wire). If resistance is less than 5 ohms, repair short to ground in Red/Dark Blue wire. If resistance is more than 5 ohms, replace headlight delay relay.