Test 103A - Diagnosing Wiper System Problems
WARNING: This page is about a different car, the 1997 Eagle Vision, 1997 Dodge Intrepid, 1997 Chrysler LHS, and 1997 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform SYMPTOM ID TEST 1A
- IDENTIFYING VEHICLE EQUIPMENT & SYSTEM PROBLEMS before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAMS
. Drive vehicle to update OTIS and perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Diagnosis of the wiper system is separated into 8 categories. With ignition switch in ON position, operate wiper system in following modes:
- High Speed
- Low Speed
- Intermittent Speed
- Wash Mode (Wipers Off)
- Identify problem area(s) listed in TEST 103A DIAGNOSTIC TEST DIRECTORY table and perform indicated test(s) in order listed.
TEST 103A DIAGNOSTIC TEST DIRECTORY
| Complaint | Perform |
|---|---|
| Wipers Do Not Operate In Any Speed | TEST 104A |
| Wipers Do Not Operate In High Speed | TEST 105A |
| Wipers Do Not Operate In Low Speed | TEST 106A |
| Wipers Do Not Operate In Intermittent Speed | TEST 107A |
| Wipers Do Not Park In OFF Position | TEST 108A |
| Wiper/Wash Function Not Operating Properly | TEST 109A |
| Wipers Operate In High Speed Only | TEST 110A |
| Wipers Run Constantly With Ignition On | TEST 111A |