Test 77A - Key-In Lamp On Constantly
WARNING: This page is about a different car, the 1997 Eagle Vision, 1997 Dodge Intrepid, 1997 Chrysler LHS, and 1997 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform TEST 75A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
Turn ignition off. Disconnect Body Control Module (BCM) Bone connector. If key-in lamp goes off, replace BCM. If key-in lamp does not go off, repair short to ground in Yellow/Red wire.