Test 86A - Testing OTIS Switches

WARNING: This page is about a different car, the 1997 Eagle Vision, 1997 Dodge Intrepid, 1997 Chrysler LHS, and 1997 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform TEST 81A before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION and WIRING DIAGRAMS . Drive vehicle to update OTIS and perform TEST VER-1 - VERIFICATION PROCEDURE after each repair.

CAUTION: Always turn ignition off prior to disconnecting any module connector.

Turn ignition off. Leave key in ignition switch. Open left front door. If chime does not sound, go to TEST 33A . If chime sounds, go to next step.
Turn ignition on. Close left front door. Press each OTIS button and listen for beep. If beep is not heard, replace OTIS module. If beep is heard, switches are currently working properly.