Test 133F - Bus Short To Battery
WARNING: This page is about a different car, the 1997 Eagle Vision, 1997 Dodge Intrepid, 1997 Chrysler LHS, and 1997 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
Ensure all doors are closed and courtesy lights are off. Using scan tool in ohmmeter mode, measure resistance on auto temp control head connector, terminal No. 6 (Black/Light Green wire). If resistance is 30 ohms or greater, repair open Black/Light Green wire. If resistance is less than 30 ohms, replace auto temp control head module.
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.