Verification Test VER-1A - Body Verification Test
WARNING: This page is about a different car, the 1998 Dodge Intrepid and 1998 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Reconnect all previously disconnected components and connectors. If BCM was replaced, program all RKE transmitters, recalibrate HVAC doors and program other options as necessary.
- If battery was disconnected, start engine and recalibrate HVAC doors using scan tool.
- Ensure ignition is on. Erase all DTCs using scan tool. Turn ignition off and wait 5 seconds. Turn ignition on and fully operate system that was malfunctioning.
- If system is not operating properly, go to SYSTEM ID TEST 1A . Using scan tool, read Body DTCs. If any DTCs are present, go to SYSTEM ID TEST 1B . If no DTCs are present, system is operating correctly and customer's complaint cannot be duplicated, repair is complete.