Test 101A - All Doors (Except Left Front) Fail To Unlock
NOTE:
Perform TEST 95A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAMS
. Drive vehicle to update OTIS and perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
- Remove door unlock relay from junction block. See Figure . Junction block is located behind end cover, on left side of instrument panel. Go to next step.
- Using scan tool in ohmmeter mode, measure resistance at terminal "E" (Black wire) on door unlock relay socket. If resistance is 5 ohms or greater, repair open Black wire. If resistance is less than 5 ohms, go to next step.
- Using scan tool in voltmeter mode, measure voltage at terminal "C" (Pink/Violet wire) on door unlock relay socket. Depress and hold door lock switch to UNLOCK position. If voltage is 10 volts or less, repair open Pink/Violet wire. If voltage is more than 10 volts, replace door unlock relay.