Test 102A - Remote Keyless Entry Problem
NOTE:
Perform TEST 95A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAMS
. Drive vehicle to update OTIS and perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
Determine problem with Remote Keyless Entry (RKE) system and perform appropriate test listed in DIAGNOSING RKE SYSTEM table.
DIAGNOSING RKE SYSTEM
| Complaint | Perform |
|---|---|
| All Locks Fail To Operate Correctly, And Trunk May Open Or Fail To Close On Lock Command | TEST 102B |
| Transmitter Programming | TEST 102D |
| RKE Inoperative Or Operates Incorrectly With Known Good Transmitter | TEST 102E |
| Horn Does Not Sound (Chirp) | TEST 102F |
| Cancel Horn Chirp | TEST 102G |
| Change Rear Release To Single Button Depress | TEST 102H |