LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1997 >> LHS >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Computer Relearn Procedures) >> Relearn Procedures >> Pinion Factor Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinion Factor Procedure

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1996 Plymouth Voyager, 1996 Plymouth Neon, 1996 Plymouth Grand Voyager, 1996 Plymouth Breeze, and 1996 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pinion factor procedure must be performed if Transaxle Control Module (TCM) is replaced or changed from one vehicle to another. Procedure must be used to calibrate TCM for different equipment combinations to provide speedometer operation and correct readings. Failure to perform this procedure will result in no speedometer operation.
    NOTE: It may be necessary to consult manufacturer to determine Final Drive Ration (FDR) number when performing pinion factor procedure.
  2. Connect DRB to data link connector, located near brake pedal at bottom of instrument panel. Using proper cartridge and DRB manufacture's instructions, move through program to enter 41TE/AE menu. Select ADJUSTMENTS function.
  3. Select PINION FACTOR function. Select appropriate Final Drive Ratio (FDR) number and then the tire size. Remove DRB. Road test vehicle and verify speedometer operation.
scientia non olet · About LEMON Manuals