LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1997 >> LHS >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Relearn Procedures >> Computer Relearn Procedures >> Transaxle Shift Quality Quick Learn Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transaxle Shift Quality Quick Learn Procedure

  1. Transaxle shift quality quick learn procedure must be performed to provide proper transaxle operation. Transaxle shift quality quick learn procedure must be performed using Chrysler's Diagnostic Readout Box (DRB-III) scan tool.
  2. Following conditions must be met when performing transaxle shift quality quick learn procedure:
    • Brakes must be applied.
    • Engine speed must be greater than 500 RPM.
    • Throttle position sensor angle must be less than 3 degrees.
    • Shift lever must remain in designated position until prompted to shift to overdrive.
    • Shift lever must remain in overdrive after the shift to overdrive until scan tool indicates procedure is complete.
    • Calculated oil temperature must be within 60-200°F (16-93°C).
  3. Connect scan tool to 16-pin data link connector, located below driver's side of instrument panel. Install cartridge in scan tool.
  4. Red and Green lights on scan tool will light up and then begin to flash. Wait until both lights stop flashing. Press No. 4 button (SELECT SYSTEM) on scan tool keypad. Press No. 2 button (TRANSMISSION) on scan tool keypad.
  5. Press No. 1 button on scan tool keypad. Wait for scan tool to perform the Bus Test, Initialize Test and Transmission Control Module Part Number Test before continuing.
  6. Press No. 5 button (ADJUSTMENTS) on scan tool keypad. Press No. 3 button (QUICK LEARN) on scan tool keypad. Follow instructions displayed on scan tool. When transaxle shift quality quick learn procedure is complete, remove scan tool.
scientia non olet · About LEMON Manuals