LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1999 >> LHS >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Memory System Test 43B >> Inoperative Memory Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inoperative Memory Switch

NOTE: Perform MEMORY SYSTEM TEST 43A  before proceeding with this test. For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER - INTRODUCTION. Perform VERIFICATION TEST: VER-4A  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
NOTE: Ensure seat frame is connected to ground if seat is unbolted from vehicle.

Disconnect Memory Heated Seat/Mirror Module (MHSMM) 26-pin harness connector. MHSMM is located under front of seat. See Figure. Connect jumper wire between ground and terminal No. 6 (Pink/Red wire) on memory switch harness connector. Using ohmmeter, measure resistance between ground and terminal No. 12 (Pink/Red wire) on MHSMM harness connector. If resistance is 5 ohms or greater, repair open Pink/Red wire. If resistance is less than 5 ohms, replace MHSMM.

scientia non olet · About LEMON Manuals