DECKLID Release Motor Output Failure
NOTE:
Perform POWER DOOR LOCK TEST 1A before proceeding with this test. For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST: VER-2A after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Disconnect decklid release motor connector. Using scan tool, erase DTCs. Cycle ignition switch off, then on. Using scan tool, read DTC's. Wait 30 seconds. While monitoring scan tool, press and hold decklid release switch for 30 seconds. If decklid release motor output DTC reset, go to next step. If decklid release motor output DTC is not reset, replace decklid release motor.
- Remove Body Control Module (BCM) from junction block. BCM is mounted to junction block located behind left end cap of instrument panel. See Figure.