LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1999 >> Sebring LXi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Engine Testing >> No Start Tests >> No Start Testing Procedures >> Avenger & Sebring Coupe 2.0L
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Avenger & Sebring Coupe 2.0L

  1. Remove No. 2 spark plug cable. Insert new spark plug in cable boot. Ground body of spark plug and crank engine. If spark occurs, check for spark at remaining spark plug cables. If no spark occurs, check camshaft position sensor and crankshaft position sensor. See SELF-DIAGNOSTICS - AVENGER & SEBRING COUPE - 2.0L article. If spark from one or more cables is weak or missing, check ignition coil and spark plug cables.
  2. Disconnect 3-pin coil wiring harness connector. Check primary coil resistance between center coil terminal and each outer coil terminal. Resistance should be .51-.61 ohm. Remove spark plug cables. Check secondary coil resistance between coil towers No. 1 and No. 4. Check secondary coil resistance between coil towers No. 2 and No. 3. Resistance should be 11,500-13,500 ohms. Replace coil if any resistance is not as specified.
  3. Remove each spark plug cable. Using an ohmmeter, check resistance of each spark plug cable. Resistance should be 8000 ohms or less. Replace any spark plug cable that has resistance more than 8000 ohms. Check spark plugs.
scientia non olet · About LEMON Manuals