Programming Transmitter

NOTE: For more information, see TSB REMOTE KEYLESS ENTRY (RKE) PROGRAMMING PROCEDURES .

NOTE: To program new RKE transmitter using following procedure, at least one transmitter must be already programmed. If all transmitters are lost, a scan tool must be used to program new transmitters. For transmitter programming procedures using scan tool, see BODY CONTROL MODULES - CONCORDE, INTREPID, LHS & 300M article.

Place gear selector in PARK. Turn ignition on. Using a previously programmed transmitter, press UNLOCK button on transmitter for minimum of 4 seconds, and while still holding UNLOCK button, press PANIC button also. Release both buttons within 10 seconds total depressed time. BCM will chime. Press any button on each additional transmitter to be programmed. BCM will chime as each button is learned. To exit program mode, turn ignition off, or wait 32 seconds. BCM will chime again.

Once transmitters have been programmed, horn chirp can be enabled/disabled by sending horn chirp toggle operation code to BCM. Enable procedure can be performed using scan tool, or by performing procedure in PROGRAMMING HORN ENABLE/DISABLE .