LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Self-Diagnostics >> Programming >> Powertrain Control Module >> Programming Powertrain Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming Powertrain Control Module

  1. Connect scan tool to Data Link Connector (DLC), located under left side of instrument panel. See Figure. Ensure shift selector is in Park or Neutral. Turn ignition on. Using scan tool, enter correct VIN and mileage into PCM. Using scan tool manufacturer's instructions, clear DTCs from ABS module and ACM. If equipped with Sentry Key Immobilizer Module (SKIM), go to next step. If not equipped with SKIM, programming is complete.
  2. Using scan tool, select THEFT ALARM, SKIM and then MISCELLANEOUS. Select PCM REPLACED. Place the SKIM in SECURED ACCESS MODE by entering the appropriate Personal Identification Number (PIN) for this vehicle. PIN may be obtained from the owner, vehicle's invoice, or from the manufacturer. Press ENTER to transfer secret key data from SKIM to the PCM. This will enable the vehicle to start.
  3. If 3 attempts are made to enter the SECURED ACCESS MODE by using an incorrect PIN, the SECURED ACCESS MODE will be locked out for one hour. To exit lock out mode, leave ignition on with all accessories turned off. After one hour, enter correct PIN. It may be necessary to monitor battery voltage and connect a battery charger.
scientia non olet · About LEMON Manuals