LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P1294: Target Idle Not Reached >> Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P1294: Target Idle Not Reached: Testing

NOTE: Fixed Orifice Adapter (6457) is needed to perform the following test.
  1. Turn ignition on. Using scan tool, read DTCs. If GLOBAL GOOD TRIP counter is displayed and displayed count is "0", go to next step. If GLOBAL GOOD TRIP counter is not displayed or displayed count is not "0", no problem is indicated at this time. Test is complete.
  2. Turn ignition off. Ensure throttle plate is fully closed against stop. Check throttle plate and linkage for binding. Repair throttle plate and linkage as necessary. If throttle plate and linkage are okay, go to next step.
  3. Start engine and allow it to idle. Check engine, brake booster and vacuum hoses for leaks. Ensure Positive Crankcase Ventilation (PCV) system is functioning properly. See EMISSION SYSTEMS & SUB-SYSTEMS in appropriate SYSTEM & COMPONENT TESTING article. Repair vacuum leaks as necessary. If PCV system is okay and no vacuum leaks exist, go to next step.
  4. Turn ignition off. Disconnect PCV hose and cap hose fitting on PCV valve. Disconnect purge hose from fitting on throttle body. Start engine. Ensure all accessories are off. Allow engine to reach normal operating temperature. Using scan tool, select ENGINE SYSTEM TESTS, then MINIMUM AIR FLOW. Follow scan tool instructions and perform minimum airflow function. If engine speed is 550-1300 RPM, no problem is indicated at this time. Test is complete. If engine speed is not 550-1300 RPM, go to next step.
    WARNING: In the following step. clean throttle body in a well ventilated area. Wear rubber or butyl gloves. Do not let Mopar parts cleaner come in contact with eyes or skin. Wash thoroughly after using cleaner.
  5. Turn ignition off. Remove throttle body. See FUEL SYSTEMS in REMOVAL & INSTALLATION article. Holding throttle open, spray entire throttle body bore and manifold side of throttle plate with Mopar parts cleaner. Also clean Idle Air Control (IAC) motor passage. Using compressed air, blow dry throttle body. Reinstall throttle body. Install .125" Fixed Orifice Adapter (6457) to purge hose vacuum fitting on throttle body. Start engine. Ensure all accessories are off. Allow engine to reach normal operation temperature. Using scan tool, select ENGINE SYSTEM TESTS, then MINIMUM AIR FLOW. Follow scan tool instructions and perform minimum airflow function. If engine speed is 550-1300 RPM, no problem is indicated at this time. Test is complete. If engine speed is not 550-1300 RPM, replace throttle body.
scientia non olet · About LEMON Manuals