Installation - Downstream 1/2, 2/2
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
The O2 sensor are located at the outlet ends of the catalytic converter.
Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to the threads of a new oxygen sensor.
- Install the O2 sensor. Tighten to 28 N.m (20 ft. lbs.) torque.
- Connect the O2 sensor wire connector.
- Lower the vehicle.
- Install the negative battery cable.