Starter Motor: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, 2002 Chrysler 300M, and 2001 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the battery negative remote cable from remote ground post (Fig 1).

Fig 1: Removing Negative Battery Cable
Courtesy of DAIMLERCHRYSLER CORP.
Raise vehicle.
Remove three bolts attaching starter to engine (Fig 2).

Fig 2: Removing Starter (3.5L Shown, 2.7L Is Similar)
Courtesy of DAIMLERCHRYSLER CORP.
Remove battery positive feed wire from starter.
Remove starter solenoid assembly from transmission housing. Position the starter to gain access to the Connector Positive Assurance (CPA) wiring connector.
Position jack stand beneath engine and slightly lift to relieve pressure from left engine mount.
Remove three left engine mount mounting bolts from engine block.
Jack engine up slightly to give more room to maneuver starter assembly.
Slide rear of starter motor out between catalyst and engine mount.
Disconnect posi-lock starter solenoid connector.
Remove the starter from vehicle.