Diagnosis And Testing - Power Mirror Switch
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Remove power mirror switch.
- Disconnect wire harness connector from back of power mirror switch.
- Using an ohmmeter, test for continuity between the terminals of the switch (Fig 1) as shown in MIRROR SWITCH TEST .
- If test results are not obtained as shown in the Mirror Switch Test table, replace the switch.
MIRROR SWITCH TEST
| SWITCH POSITION MOVE BUTTON | CONTINUITY BETWEEN TERMINALS |
|---|---|
| MIRROR IN "L" POSITION | |
| UP | PIN 11 TO 12 PIN 12 TO 13 PIN 9 TO 1 |
| RIGHT | PIN 11 TO 1 PIN 9 TO 7 PIN 9 TO 8 |
| DOWN | PIN 11 TO 1 PIN 9 TO 12 PIN 9 TO 13 |
| LEFT | PIN 11 TO 7 PIN 11 TO 8 PIN 9 TO 1 |
| MIRROR IN "R" POSITION | |
| UP | PIN 11 TO 12 PIN 11 TO 13 PIN 9 TO 2 |
| RIGHT | PIN 11 TO 6 PIN 9 TO 7 PIN 9 TO 8 |
| DOWN | PIN 11 TO 6 PIN 9 TO 12 PIN 9 TO 13 |
| LEFT | PIN 11 TO 7 PIN 11 TO 8 PIN 9 TO 6 |