Specifications Index
CONCORDE, INTREPID, LHS & 300M SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning - Automatic System | |||
| Service | SPECIFICATIONS | ||
| Torque | N/A | ||
| Air Conditioning - Manual System | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front Driveshaft Nut (Except LHS) | 105 Ft. Lbs. (150 N.m) | ||
| Front Driveshaft Nut (LHS) | 120 Ft. Lbs. (163 N.m) | ||
| Rear Spindle Retaining Nut | 124 Ft. Lbs. (168 N.m) | ||
| Brakes | |||
| Bleeding Sequence | |||
| Without ABS | BLEEDING PROCEDURE | ||
| With ABS | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | ON-VEHICLE TESTING | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Pressure Cap Pressure | 16 PSI | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical (3.2L & 3.5L) | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Oil pressure is 5 psi (0.35 kg/cm2 ) at idle, and 45-105 psi (3.1-7.3 kg/cm2 ) at 3000 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Drive Plate/Flexplate Torque | 70 Ft. Lbs. (95 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Fuel filter is incorporated into the fuel pressure regulator. A separate frame mounted fuel filter is not used. Refer to FUEL FILTER/FUEL PRESSURE REGULATOR . | ||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS . Wire routing is located in Figures. | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Lug Nut Torque | 100 Ft. Lbs. (135 N.m) Tighten nuts in crisscross sequence to half torque, then tighten to full torque. | ||