LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> LHS >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> Removal & Installation >> Body Control Module (BCM) >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

NOTE: After replacement of BCM, vehicle will not start until VTSS system is enabled.
  1. Body Control Module (BCM) is attached to junction block. Junction block must be removed to enable removal of BCM. Junction block is located behind left side of instrument panel. See Figure .
  2. Unbolt remote negative cable terminal. Remote negative battery cable terminal is located between right strut tower and air cleaner air intake hose. Open driver's door. Pry off left instrument panel end trim cap. Remove left side under dash cover. Remove trunk lid switch and wiring.
  3. Disconnect harness connectors from junction block. Remove junction block by pulling straight down from mounting bayonet. Disconnect BCM and RKE module connectors. Remove 4 screws holding BCM to junction block and separate BCM from junction block.
  4. To install, transfer RKE module to replacement BCM. To complete installation, reverse removal procedure. Using scan tool, enable VTSS system.
scientia non olet · About LEMON Manuals