Scan Tool Method

Obtain vehicle's unique PIN assigned to SKIM from vehicle owner or manufacturer. Cut blank key. Insert key into ignition switch. Connect scan tool to Data Link Connector (DLC). DLC is located on bottom of instrument panel, to left of brake pedal. See Figure. Turn ignition on. Using scan tool, select BODY, THEFT ALARM, then SKIM. Select MISCELLANEOUS, then PROGRAM NEW KEY. Enter 4-digit PIN. When programming is completed, SKIM will exit SECURED ACCESS mode and display status of key. PROGRAMMING SUCCESSFUL is displayed if SKIM smart key programming succeeds. If ignition key programming is unsuccessful, one of the following status messages may be displayed:

• LEARNED KEY IN IGNITION is displayed if key in the ignition switch has already been programmed into vehicle's SKIM.
• 8 KEYS ALREADY LEARNED, PROGRAMMING NOT DONE is displayed if 8 keys have already been programmed into SKIM. If a new key needs to be added due to a lost or defective key, the ERASE ALL KEYS function has to be performed. Original 7 keys plus additional new key may then be reprogrammed into SKIM.
• PROGRAMMING NOT ATTEMPTED is displayed after an ERASE ALL KEYS function is executed.
• PROGRAMMING KEY FAILED is displayed if further diagnosis is required.

To program additional keys, turn ignition off. Remove current programmed key and insert next new blank key. Turn ignition on. Reenter SECURED ACCESS mode function and repeat PROGRAM NEW KEY procedure.