LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Sebring JXi >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Relearn Procedures >> Sentry Key Immobilizer System (Skis) Initialization Procedure >> General Information
April 5, 2026: LEMON Manuals is launched! Read the announcement.

General Information

If Powertrain Control Module (PCM) is replaced, unique secret key data must be transferred from Sentry Key Immobilizer Module (SKIM) to Powertrain Control Module (PCM). This procedure requires SKIM to be placed in SECURED ACCESS mode using 4-digit Personal Identification Number (PIN) code.

If PCM and SKIM are replaced at the same time, program Vehicle Identification Number (VIN) into PCM first. All vehicle keys will need to be replaced and programmed into new SKIM.

SECURED ACCESS mode is not required to check programmed status of key.

If 3 attempts are made to enter secured access mode using an incorrect PIN code, SECURED ACCESS mode will be locked out for one hour. To exit lock out mode, turn ignition switch to on position continuously for one hour then enter the correct PIN code. Ensure all accessories are turned off. Monitor battery state and connect battery charger as necessary.

To program smart keys using "customer programming method" requires 2 valid smart keys. See CUSTOMER LEARN PROGRAMMING METHOD.

CAUTION: If wrong country code is programmed into SKIM when requested, SKIM must be replaced.
scientia non olet · About LEMON Manuals