DTC P0601: Internal Controller Failure
NOTE:
Internal controller operation is monitored when ignition is on. DTC may be stored in Powertrain Control Module (PCM) when an internal checksum for software failed and does not match the calculated value. Possible causes are a defective PCM.
Turn ignition on with engine off. Using scan tool, check for DTCs. If DTC P0601: INTERNAL CONTROLLER FAILURE does not exist, test is complete. If DTC P0601: INTERNAL CONTROLLER FAILURE exists, replace PCM. PCM is located between driver's side front fender and power distribution center, near battery. Perform TEST VER-2A .