LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft Systems >> Programming >> Customer Learn Programming Method
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customer Learn Programming Method

CAUTION: To program sentry keys using "customer programming method", 2 valid sentry keys are required. If 2 valid sentry keys are not available, use scan tool to program sentry keys. See PROGRAMMING SENTRY KEYS USING SCAN TOOL  .
NOTE: The following steps must be completed in proper order. Sentry Key Immobilizer System (SKIS) will automatically exit CUSTOMER LEARN programming mode if time allotted is exceeded, or if 8 keys have already been programmed.
  1. Ensure new sentry key blank is cut before proceeding. Insert one of the 2 valid sentry keys into ignition. Turn ignition switch to ON position.
  2. After ignition switch has been turned to ON position for 3 seconds, but no more than 15 seconds, turn ignition switch to OFF position. Remove key. Insert second valid sentry key and turn ignition switch to ON position within 15 seconds.
  3. About 10 seconds after completion of step  2 , sun sensor/Vehicle Theft Security System (VTSS) Light Emitting Diode (LED) indicator will flash and a single tone will be heard. This indicates system has entered CUSTOMER LEARN programming mode.
  4. Within 50 seconds, turn ignition switch to OFF position. Remove valid sentry key. Insert blank sentry key. Turn ignition switch to ON position.
  5. After about 10 seconds, a single tone will be heard. Sun sensor/VTSS LED indicator will stop flashing and stay on for about 3 seconds to indicate sentry key has been successfully programmed.
  6. SKIS will immediately return to normal operation after exiting CUSTOMER LEARN programming mode.
  7. Repeat procedure for each additional sentry key to be programmed.
scientia non olet · About LEMON Manuals