LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Communications System >> Head Status RX Failure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Head Status RX Failure

NOTE: After making any repairs, perform BODY CONTROL MODULES SYSTEM VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn ignition off. Remove and inspect fuse No. 14 in junction block. If fuse is okay, go to step  3 . If fuse is open, go to next step.
  2. Replace fuse No. 14. Turn ignition on, then off. Remove and inspect fuse No. 14. If fuse is open, replace fuse and repair short to ground in Dark Blue/White wire between junction block and Mechanical Instrument Cluster (MIC). If fuse is okay, fault may be intermittent. Check related wiring and connectors for poor connections or damage to wiring harness. See WIRING DIAGRAMS  . Repair any problems found as necessary. If no problems are found, check if any Technical Service Bulletins (TSBs) apply to vehicle. If no TSBs apply, test is complete.
  3. Ensure ignition is off. Install fuse No. 14. Remove Body Control Module (BCM) from back of junction block. Ensure all junction block connectors are completely connected. Go to next step.
  4. Turn ignition on. Measure voltage on terminal No. 5 at BCM connector on back of junction block. See Figure . If voltage is more than 10 volts, replace BCM. If voltage is 10 volts or less, replace junction block.
scientia non olet · About LEMON Manuals