LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Memory Systems >> Driver Mirror Vertical Sensor Out Of Range Low
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driver Mirror Vertical Sensor Out Of Range Low

NOTE: After making any repairs, perform MEMORY SYSTEMS VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM) connector C1. Turn ignition on. Measure voltage on MHSMM connector C1 terminal No. 7, driver mirror vertical position signal circuit (Yellow/Orange wire). See Figure . If voltage is 4.5-5.0 volts, replace MHSMM. If voltage is not 4.5-5.0 volts, leave MHSMM connector C1 disconnected, and go to next step.
  2. Turn ignition off. Disconnect driver mirror connector. Measure resistance of driver mirror vertical position signal circuit (Yellow/Orange wire) between driver mirror connector terminal No. 7 and MHSMM connector C1 terminal No. 7. See Figure . If resistance is less than 5 ohms, leave connectors disconnected, and go to next step. If resistance is 5 ohms or more, repair open in Yellow/Orange wire.
  3. Measure resistance between ground and driver mirror connector terminal No. 7, driver mirror horizontal position signal circuit (Yellow/Orange wire). If resistance is less than 100 ohms, repair short to ground in Yellow/Orange wire. If resistance is 100 ohms or more, leave driver mirror connector disconnected, and go to next step.
  4. Ensure MHSMM connector is properly connected. Turn ignition on. Measure voltage on driver mirror connector terminal No. 6, driver mirror 5-volt supply circuit (Gray/Light Blue). If voltage is 4.5-5.0 volts, replace driver mirror. If voltage is not 5.5-5.0 volts, leave driver mirror connector disconnected, and go to next step.
  5. Turn ignition off. Disconnect MHSMM connector C2. Measure resistance of driver mirror 5-volt supply circuit (Gray/Light Blue wire) between driver mirror connector terminal 6 and MHSMM connector C2 terminal No. 7. If resistance is less than 5 ohms, replace MHSMM. If resistance is 5 ohms or more, repair open in Gray/Light Blue wire.
scientia non olet · About LEMON Manuals