LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Power Door Locks/Remote Keyless Entry System >> Driver Door Fails To Unlock From Any Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driver Door Fails To Unlock From Any Switch

NOTE: After making any repairs, perform BODY CONTROL MODULES SYSTEM VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn ignition off. Remove driver door unlock relay from junction block. See Figure . Connect a 12-volt test light between ground and door unlock relay connector terminal No. 87. If test light illuminates brightly, leave driver door unlock relay removed, and go to next step. If test light does not illuminate brightly, replace junction block.
  2. Connect test light between ground and door unlock relay connector terminal No. 88. If test light illuminates brightly, leave driver door unlock relay removed, and go to next step. If test light does not illuminate brightly, replace junction block.
  3. Ensure ignition is off. Connect scan tool to Data Link Connector (DLC). Connect test light between driver door unlock relay connector terminals No. 88 and 90. Turn ignition on. Using scan tool, actuate driver door unlock relay. If test light flashes, replace driver door unlock relay. If test light does not flash, leave driver door unlock relay removes, and go to next step.
  4. Turn ignition off. Remove Body Control Module (BCM) from back of junction block. Measure resistance between driver door unlock relay connector terminal No. 90 and terminal No. 13 at BCM connector on back of junction block. See Figure and Figure . If resistance is less than 5 ohms, replace BCM. If resistance is 5 ohms or more, replace junction block.
scientia non olet · About LEMON Manuals