LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Verification Tests >> Transmission Verification Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Verification Test

NOTE: If Transmission Control Module (TCM) or torque converter was replaced or transmission has been repaired or replaced, scan tool must be used to perform quick learn procedure. See PROGRAMMING  .
  1. Remove all test equipment and jumper wires. Connect any disconnected components. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, clear DTCs from all modules. Using scan tool, check transmission temperature. Start vehicle and let idle until transmission temperature is greater than 110°F (43°C). Go to next step.
  2. Check transmission fluid level and adjust as necessary. Using scan tool, monitor engine RPM. Test drive vehicle from a stop to 45 MPH with a constant throttle opening of 20-25 degrees 15-20 times, allowing transmission to upshift through all gears. Go to next step.
  3. While driving at less than 25 MPH, make 5-8 wide open throttle kickdowns to 1st gear, allowing 5 seconds in 2nd and 3rd gears between each kickdown. Using scan tool, retrieve DTCs from all modules during test drive. If no DTCs exist, system is operating correctly and customer's complaint cannot be duplicated, repair is complete. If any DTCs exist, perform appropriate test(s). See DIAGNOSTIC TROUBLE CODE DEFINITIONS  .
scientia non olet · About LEMON Manuals