LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Ford Motor Co. >> Instrument Cluster Programming >> Instrument Cluster Programming Procedure "B"
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Instrument Cluster Programming Procedure "B"

NOTE: Passive Anti-Theft System (PATS) MUST be reconfigured after replacement of Virtual Instrument Cluster (VIC). Perform INSTRUMENT CLUSTER PROGRAMMING PROCEDURE "B" . Then erase and program all ignition keys to be used on vehicle. See appropriate PASSIVE ANTI-THEFT SYSTEMS article in ACCESSORIES & EQUIPMENT.
  1. Turn ignition switch to OFF position. Using NGS tester, retrieve and record continuous DTCs. Clear continuous DTCs and perform instrument cluster self-test. If DTC B2139 is retrieved, go to next step. If DTC B2139 is not retrieved, system is okay at this time.
  2. Perform security access for instrument cluster. See SECURITY ACCESS PROCEDURE . Using NGS tester, select PARAMETER RESET command for instrument cluster. Using NGS tester, select PARAMETER RESET command for PCM. Turn ignition switch to RUN position for 3 seconds. Clear Continuous Memory DTCs.
  3. Turn ignition switch to OFF position. Using NGS tester, perform instrument cluster self-test. If DTC B2139 is not retrieved, system is okay at this time. If DTC B2139 is retrieved, verify PCM calibration is correct for vehicle. If calibration is okay, repeat steps  2 and  3 . If DTC B2139 still exists, replace instrument cluster. Cycle ignition switch from OFF to ON position using 2 encoded ignition keys. Repeat steps  1- 3 . Clear Continuous Memory DTCs. Repeat instrument cluster self-test. If DTC B2139 still exists, replace PCM.
scientia non olet · About LEMON Manuals