Password Learn Procedure For Anti-Theft System
NOTE:
If Tech 2 scan tool and Techline terminal is available, a 10 minute procedure is available. Follow scan tool manufacturer's instructions.
- Turn ignition switch to ON position, engine off. Attempt to start engine, then release key to ON position (vehicle will not start). Observe SECURITY telltale, after approximately 10 minutes, telltale will turn off. Turn ignition switch to OFF position and wait 5 seconds.
- Repeat step 1 two more times for a total of 3 cycles/30 minutes. Vehicle is now ready to relearn Passlock™ Sensor Data Code and/or passwords on next ignition switch transition from off to crank.
- Start engine (vehicle has now learned Passlock™ Sensor Data Code and/or password). Using scan tool, clear DTCs.
NOTE:
Vehicle learns Passlock™ Sensor Data Code and/or password on next ignition switch transition from off to crank. You must turn ignition off before attempting to start vehicle.