Memory Position No. 1 Stuck
NOTE:
After making any repairs, perform MEMORY SYSTEMS VERIFICATION TEST
under VERIFICATION TESTS.
- Turn ignition off. Disconnect memory set switch connector. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, read MEM POS 1 SW status. If scan tool does not display OPEN, leave memory set switch connector disconnected, and go to next step. If scan tool displays OPEN, replace memory set switch.
- Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM) connector C1. Measure resistance between ground and memory set switch connector terminal No. 6, memory position 1 switch sense circuit (Pink/Red wire). See Fig 1 . If resistance is less than 100 ohms, repair short to ground in Pink/Red wire. If resistance is 100 ohms or more, replace MHSMM.