LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Intrepid ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Verification Tests >> Powertrain Verification Test VER-1
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Verification Test VER-1

NOTE: If replacing Powertrain Control Module (PCM), the correct vehicle mileage and Vehicle Identification Number (VIN) must be programmed into PCM to prevent Diagnostic Trouble Codes (DTC) from being stored in Anti-Lock Brake System (ABS) module and Air Bag Control Module (ACM). If replacing PCM and vehicle is equipped with Sentry Key Immobilizer Module (SKIM), secret key data must also be updated to enable engine starting. See PROGRAMMING  .
  1. Inspect vehicle to ensure all engine components are connected properly. Reassemble and reconnect components as necessary. If repair procedure did not include replacing PCM, go to next step. If PCM has been replaced and has already been programmed, go to next step. If PCM has been replaced but has not been programmed, program PCM and clear DTCs. See PROGRAMMING  . After PCM is programmed, go to next step.
  2. Inspect engine oil for fuel contamination. Change engine oil and filter as necessary. Attempt to start engine. If engine starts, go to next step. If engine does not start, go to appropriate TROUBLE SHOOTING - NO CODES article for additional testing. Also, refer to any technical service bulletins that may apply.
  3. Run engine for one warm-up cycle to verify operation. Using scan tool, confirm that no DTCs or secondary indicators are present and that all components are functioning properly. If a DTC is present, repair is not complete. Perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If no DTCs are present, repair is complete.
scientia non olet · About LEMON Manuals