RKE Program Mode Entered Without Program Request
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
Monitored & Set Condition
- When Monitored: Continuously.
- Set Condition: The BCM receives an indication from the RKE module that it has entered program mode without the BCM requesting so.
Possible Causes:
- RKE Program Mode Entered Without Program Request
Testing
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). Replace Remote Keyless Entry (RKE) module. Using scan tool, program all RKE transmitters to be used with vehicle. See REMOTE KEYLESS ENTRY TRANSMITTER under PROGRAMMING. Go to next step.
- Using scan tool, clear Body Control Module (BCM) Diagnostic Trouble Codes (DTC). Using RKE transmitters, lock and unlock vehicle several times. Using scan tool, retrieve BCM DTCs. If RKE PROGRAM MODE ENTERED WITHOUT PROGRAM REQUEST DTC resets, replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If RKE PROGRAM MODE ENTERED WITHOUT PROGRAM REQUEST DTC does not reset, test is complete.